Skip to main content

v1.0

Major VersionM

by StJohn Vuetilovoni

Parts

No parts specified.

  1. Using a flat headed screw driver, undo the four lid screws at each corner and remove the lid. Undo the lock nuts on either end and remove the inlet and outlet nozzles.
    • Using a flat headed screw driver, undo the four lid screws at each corner and remove the lid.

    • Undo the lock nuts on either end and remove the inlet and outlet nozzles.

    • Remove the sensor head by carefully pulling it upwards, disconnecting it from the monitor.

  2. Replace the sensor head with another Type 2 sensor.
    • Replace the sensor head with another Type 2 sensor.

    • Re-insert the nozzles and tighten using the lock-nuts, ensuring there's a tight fit against the sensor head.

    • Replace the lid and tighten the four lid screws.

Conclusion

For further support, contact Technical Support.

Tanya Taylor

Member since: 02/25/2020

141 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 60