Introduction
Use this guide to set up a schedule of automatic calibration checks using the AirCal 1000 PC software.
Note: The information you define using the software is stored on the AirCal 1000 and not on the PC containing the software.
Tools
No tools specified.
-
-
Select the Calibration Configuration option in the Functions panel.
-
Right-click to open the Run Scheduler.
-
-
-
From the drop-down boxes, select the frequency, day and start time for your calibration run.
-
Enter up to 5 points for your calibration run and define the port, dilution ratio and run time for each.
-
A run can include zero air which is defined as port 0.
-
Once all the parameters are set, click Save then click Read to ensure the run was successfully saved.
-
You can schedule up to three calibration runs for your AirCal 1000.
-
-
-
To delete a calibration run, right-click inside the run scheduler and select Remove run.
-
Run 3 is removed first, followed by run 2 and then run 1.
-
Once a run is removed, click Save then click Read to ensure the run was successfully removed.
-
For further support, contact Technical Support.
For further support, contact Technical Support.
