Skip to main content

v1.8

Minor Versionm

by StJohn Vuetilovoni

  1. From the Aeroqual Connect or Aeroqual Cloud home screen, select Configure.
    • From the Aeroqual Connect or Aeroqual Cloud home screen, select Configure.

  2. Select Settings from the side menu.
    • Select Settings from the side menu.

    • Select your local time zone from the Time zone drop-down list.

  3. By default, all gas units are presented as ppm and all particle units are presented as ug/m-3.  To change this: Select Sensor List from the side menu.
    • By default, all gas units are presented as ppm and all particle units are presented as ug/m-3. To change this:

    • Select Sensor List from the side menu.

    • Click the sensor type you want to change. This opens the Edit sensor type dialog box.

    • Select your desired measurement unit from the Display units drop down.

    • You can have a different unit for each sensor type.

    • These changes only affect how units display on the software interface. The units stored in the database are always ppm for gas and ug/m3 for particles.

  4. To  make sure data is displaying in the correct time zone and measurement units, go to your home screen and select Calibration and Service. Select Manual Entry from the side menu and look at the real-time measurements table.
    • To make sure data is displaying in the correct time zone and measurement units, go to your home screen and select Calibration and Service.

    • Select Manual Entry from the side menu and look at the real-time measurements table.

Conclusion

For further support, contact Technical Support.

2 other people completed this guide.

Tanya Taylor

Member since: 02/25/2020

141 Guides authored