Introduction
If desired, you can connect the SM50 to an external, mains-powered device, such as an alarm, siren, extractor fan or ozone generator. To do this, you need to include a separate mains rated relay.
The set point of the on-board relay activates the relay switch, which controls your external device.
The onboard relay output is 24V; 5A (max).
Note: Mains equipment should only be wired by a certified electrician.
Tools
No tools specified.
-
-
Turn the sensor board over so you can see the underside components.
-
Using the screw terminal connectors on the sensor board, wire the desired external device to either the normally open or normally closed contacts as required for your application and firmware version.
-
This diagram shows one method of connecting a SM50 to a mains-powered device.
-
For further support, contact Technical Support.
For further support, contact Technical Support.
