v1.10

Minor Versionm

by StJohn Vuetilovoni

Set control points

Written By: StJohn Vuetilovoni (and one other contributor)
  • Comments: 0
  • Favorites: 0
  • Completions: 2

Difficulty

Very easy

Steps

2

Time Required

00:10:00

Sections

1

Flags

0

Introduction

Use this guide to set control points for your connected devices.

The control pin can then be wired to control the generation of gas that’s between your specified high and low concentration limits.

  1. Press the ENTER button and select MONITOR SETUP from the main menu. Select CONTROL POINTS from the secondary menu. Select CONTROL POINTS from the secondary menu.

    • Press the ENTER button and select MONITOR SETUP from the main menu.

    • Select CONTROL POINTS from the secondary menu.

  2. The factory default set points depend on the gas sensor head you chose when you bought your handheld monitor. Use the UP/DOWN buttons to select the required high (HI) concentration set point.

    • The factory default set points depend on the gas sensor head you chose when you bought your handheld monitor.

    • Use the UP/DOWN buttons to select the required high (HI) concentration set point.

    • Press ENTER to confirm the change.

    • Use the UP/DOWN buttons to select the required low (LO) concentration set point.

    • Press ENTER to confirm the selections and return to the main menu.

Conclusion

For further support, contact Technical Support.

2 other people completed this guide.

Author

with 1 other contributor

StJohn Vuetilovoni

Member since: 02/24/2020

57 Guides authored

Team

Aeroqual Staff Member of Aeroqual Staff

2 Members

9 Guides authored