-
-
If you have a Series 500 or 300 monitor:
-
Press the ENTER button and select MONITOR SETUP from the main menu.
-
Select UNITS from the secondary menu.
-
If you have a Series 200, press the ENTER button and select UNITS from the main menu.
-
-
-
Use the UP/DOWN buttons to change the units for your particular sensor:
-
ppm or mg/m3 for a gas sensor.
-
°C or °F for a temperature and relative humidity sensor.
-
mg/m3 is the only option for a PM sensor.
-
To learn about the ppm to mg/m3 conversion factor for each sensor head, read here.
-
Press ENTER to confirm.
-
For further support, contact Technical Support.
For further support, contact Technical Support.
Cancel: I did not complete this guide.
2 other people completed this guide.
Team
