Skip to main content

v1.11

Minor Versionm

by StJohn Vuetilovoni

  1. If you have a Series 500 or 300 monitor: Press the ENTER button and select MONITOR SETUP from the main menu. Select UNITS from the secondary menu.
    • If you have a Series 500 or 300 monitor:

    • Press the ENTER button and select MONITOR SETUP from the main menu.

    • Select UNITS from the secondary menu.

    • If you have a Series 200, press the ENTER button and select UNITS from the main menu.

  2. Use the UP/DOWN buttons to change the units for your particular sensor: ppm or mg/m3 for a gas sensor.
    • Use the UP/DOWN buttons to change the units for your particular sensor:

    • ppm or mg/m3 for a gas sensor.

    • °C or °F for a temperature and relative humidity sensor.

    • mg/m3 is the only option for a PM sensor.

    • To learn about the ppm to mg/m3 conversion factor for each sensor head, read here.

    • Press ENTER to confirm.

Conclusion

For further support, contact Technical Support.

2 other people completed this guide.

StJohn Vuetilovoni

Member since: 02/24/2020

58 Guides authored

Team

Aeroqual Staff Member of Aeroqual Staff

2 Members

9 Guides authored