Introduction
Use this guide to change the monitor ID, location ID, concentration unit, logging frequency, output sensor, alarm settings, control settings, and date and time.
Note: It assumes you have already installed the monitor’s configuration software, downloaded the cable driver and connected your monitor to a PC.
-
-
Launch the Aeroqual S500 software and click Monitor > Setup from the menu bar. The Monitor Setup dialog box appears.
-
Type in, or use the up/down buttons to set desired values for monitor ID, location ID, concentration unit, logging frequency, output sensor, alarm settings, and control settings.
-
If the temperature and relative humidity sensor is connected, an option to select the temperature unit also appears.
-
Each function has a keyboard shortcut. The shortcut keys are noted alongside each function in the drop-down menus.
-
-
-
To log data, it's essential the clock on the monitor is set to the true time. Click Update Clock to set the date and time. Note: This can also be done on the monitor via its setup menu.
-
Click Save to synchronize the monitor values with those from the PC.
-
If the clock doesn't synchronize, the monitor clock battery may be flat and need replacement. In this situation, contact Technical Support.
-
For further support, contact Technical Support.
For further support, contact Technical Support.
Cancel: I did not complete this guide.
3 other people completed this guide.
Team
