Introduction
You can only connect one gas or particulate sensor head at a time to monitor. However, you are able to connect the optional temperature and humidity sensor at the same time as a gas or particulate sensor head.
-
-
Never attach the sensor head while the monitor is switched on as that can damage the monitor.
-
Make sure the monitor is turned off.
-
Keeping the the sensor head perpendicular, carefully insert the keyed connector at the base of the sensor head into the top of the monitor.
-
To avoid damage to the sensor, never shake or invert the monitor when a sensor is attached.
-
When the sensor is fully inserted, turn on the monitor.
-
-
-
Turn the monitor off by pressing and holding the POWER button for 2 seconds until the monitor beeps.
-
When the display turns blank and the monitor stops operating, carefully detach the keyed connector at the base of the sensor head from the monitor.
-
If you remove the sensor head while the monitor is switched on and without AC/DC adapter connected, the monitor automatically shuts down.
-
For further support, contact Technical Support.
For further support, contact Technical Support.
Cancel: I did not complete this guide.
16 other people completed this guide.
Team
