Skip to main content

v1.8

Minor Versionm

by Tanya Taylor

Introduction

While logging directly to a PC, you can view data in two different table formats.

Note: It assumes you have already installed the monitor’s configuration software, downloaded the cable driver and connected your monitor to a PC.

  1. Launch the Aeroqual S500 software and select Data > Real Time Table View or Data > Logged Data Table View from the menu bar. In Logged Data Table View, use the date, time, monitor ID, location ID and sensor filters to narrow the data and click Apply. The  Logged Data Table View shows up to 7 days of data on each page. Click >> at the bottom of the table to view the previous or next 7 days of data within the filtered data set.
    • Launch the Aeroqual S500 software and select Data > Real Time Table View or Data > Logged Data Table View from the menu bar.

    • In Logged Data Table View, use the date, time, monitor ID, location ID and sensor filters to narrow the data and click Apply.

    • The Logged Data Table View shows up to 7 days of data on each page. Click >> at the bottom of the table to view the previous or next 7 days of data within the filtered data set.

    • Only data from one monitor can be viewed in a table at a time.

Conclusion

For further support, contact Technical Support.

StJohn Vuetilovoni

Member since: 02/24/2020

47 Guides authored

Team

Aeroqual Staff Member of Aeroqual Staff

Community

1 Member

47 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 4

All Time: 24