Skip to main content

v1.20

Minor Versionm

by StJohn Vuetilovoni

Introduction

If your monitor’s inlet flow rate is lower than expected, it could be because one of the modules has a leak or is blocked. To check this, perform a leak check on the individual gas modules.

To understand how often you should perform this service activity, click here.

  1. Enter service mode so any fluctuations in the data caused from this activity can be excluded from air quality reports.
    • Enter service mode so any fluctuations in the data caused from this activity can be excluded from air quality reports.

  2. Read the PDF attached to the end of this user guide to understand the expected flow rate for each gas module.
    • Read the PDF attached to the end of this user guide to understand the expected flow rate for each gas module.

  3. Disconnect the incoming PFA tubing from the the inlet port (white ring) of the gas module.
    • Disconnect the incoming PFA tubing from the the inlet port (white ring) of the gas module.

    • Attach a high-quality flowmeter such as the TSI 4040 or the Bios Defender DryCal to the inlet port (white ring) of the gas module.

    • Reconnect the PFA tubing to the gas module’s inlet port.

    • Repeat these steps for each gas module.

Conclusion

For further support, contact Technical Support.

One other person completed this guide.

Tanya Taylor

Member since: 02/25/2020

141 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 8

All Time: 354