Skip to main content

v0.17

Minor Versionm

by StJohn Vuetilovoni

Introduction

To understand how often you should perform this service activity, click here.

  1. Enter service mode so any fluctuations in the data caused from this activity can be excluded from air quality reports.
    • Enter service mode so any fluctuations in the data caused from this activity can be excluded from air quality reports.

  2. The gas inlet flow rate is controlled by the number of gas modules installed.
    • The gas inlet flow rate is controlled by the number of gas modules installed.

    • Each gas module contributes to the overall flow rate. In other words, the inlet flow rate is equal to the sum of all of the individual flow rates.

    • Read the PDF attached to the end of this user guide to understand the expected flow rate for the main gas inlet.

  3. Remove the white inlet fitting containing the mesh filter.
    • Remove the white inlet fitting containing the mesh filter.

  4. Attach the inlet flow adaptor.
    • Attach the inlet flow adaptor.

  5. Attach a high-quality flowmeter such as the TSI 4040 or the Bios Defender DryCal to the inlet.
    • Attach a high-quality flowmeter such as the TSI 4040 or the Bios Defender DryCal to the inlet.

  6. Record the results of this service activity in  the monitor's journal.
Conclusion

For further support, contact Technical Support.

3 other people completed this guide.

Tanya Taylor

Member since: 02/25/2020

141 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 1

Past 30 Days: 11

All Time: 588